BER performance

The massive MIMO system is one of the main technologies in the fifth generation (5G) of telecommunication systems, also recognized as a highly large-scale system. Constantly in massive MIMO systems, the base station (BS) is provided with a large number of antennas, and this large number of antennas need high-quantization resolution levels analog-to-digital converters (ADCs). In this situation, there will be more power consumption and hardware costs. This paper presents the simulation performance of a suggested method to investigate and analyze the effects of different quantization resolution levels of ADCs on the bit error rate (BER) performance of massive MIMO system under different operating scenarios using MATLAB software. The results show that the SNR exceeds 12 dB accounts for only 0.001% of BER signals when the number of antennas 60 with low quantization a 2 bits’ levels ADCs, approximately. But when the antenna number rises to 300, the SNR exceeds 12 dB accounts for almost 0.01% of BER transmitted signals. Comparably with the BER performance of high quantization, 4 bits-quantization resolution levels ADCs with the same different antennas have a slight degradation. Therefore, the number of antennas is a very important influence factor.

We investigate spontaneous U(1) symmetry breaking and the associated phase transitions in rotating interacting Bose gases. Using a theoretical framework that combines mean-field analysis with rotational dynamics, we analyze how rigid rotation modifies the condensate structure and critical behavior. The study identifies the emergence of Goldstone modes and clarifies their role in the lowenergy excitation spectrum. The results provide insight into the interplay between symmetry, rotation, and many-body interactions, contributing to a deeper theoretical understanding of phase structures in Bose systems.

The performance evaluation of a multi-channel transmitter that employs an arrayed reflective electroabsorption modulator-based photonic integrated circuit and a low-power driver array in conjunction with a multi-channel receiver incorporating a pin photodiode array and integrated arrayed waveguide grating is reported. Due to their small footprint, low power consumption and potential low cost, these devices are attractive solutions for future mobile fronthaul and next generation optical access networks. A BER performance of <10 -9 at 10.3 Gbit/s per channel is achieved over 25 km of standard single mode fibre. The transmitter/receiver combination can achieve an aggregate bit rate of 82.4 Gbit/s when eight channels are active.

The aim of this paper is to study the performance of a matched filter for baseband binary transmission when subjected to Gaussian noise. A BER performance simulation model is created which consists of a BPSK encoder, a transmission SQRC filter, a Gaussian noise generator, a receive SQRT filter and a BPSK decoder. A Monte Carlo simulation technique is used to determine the dependency of BER performance on the signal to noise ratio. A MATLAB program and a MATLAB SIMULINK program was written to generate the required data. The MATLAB results show good agreement with statistical theoretical predictions.

The creation and developing of a wireless network communication that is fast, secure, dependable, and cost-effective enough to suit the needs of the modern world is a difficult undertaking. Channel coding schemes must be chosen carefully to ensure timely and error-free data transfer in a noisy and fading channel. To ensure that the data received matches the data transmitted, channel coding is an essential part of the communication system's architecture. NR LDPC (New Radio Low Density Parity Check) code has been recommended for the fifth-generation (5G) to achieve the need for more internet traffic capacity in mobile communications and to provide both high coding gain and low energy consumption. This research presents NR-LDPC for data transmission over two different multipath fading channel models, such as Nakagami-m and Rayleigh in AWGN. The BER performance of the NR-LDPC code using two kinds of rate-compatible base graphs has been examined for the QAM-OFDM (Quadrature Amplitude Modulation-Orthogonal Frequency Division Multiplexing) system and compared to the uncoded QAM-OFDM system. The BER performance obtained via Monte Carlo simulation demonstrates that the LDPC works efficiently with two different kinds of channel models: those that do not fade and those that fade and achieves significant BER improvements with high coding gain. It makes sense to use LDPC codes in 5G because they are more efficient for long data transmissions, and the key to a good code is an effective decoding algorithm. The results demonstrated a coding gain improvement of up to 15 dB at 10-3 BER.

The performance evaluation of a multi-channel transmitter that employs an arrayed reflective electroabsorption modulator-based photonic integrated circuit and a low-power driver array in conjunction with a multi-channel receiver incorporating a pin photodiode array and integrated arrayed waveguide grating is reported. Due to their small footprint, low power consumption and potential low cost, these devices are attractive solutions for future mobile fronthaul and next generation optical access networks. A BER performance of <10 −9 at 10.3 Gbit/s per channel is achieved over 25 km of standard single mode fibre. The transmitter/receiver combination can achieve an aggregate bit rate of 82.4 Gbit/s when eight channels are active.

In this paper, we present a study on the performance of directoversampling correlator-type receivers in chaos-based Direct-sequence code division multiple access (DS-CDMA) systems over frequency non-selective fading channels. At the input, the received signal is sampled at a sampling rate higher than the chip rate. This oversampling step is used to precisely determine the delayed-signal components from multipath fading channels, which can be combined together by a correlator for the sake of increasing the SNR at its output. The main advantage of using direct-oversampling correlator-type receivers is not only their low energy consumption due to their simple structure, but also their ability to exploit the non-selective fading characteristic of multipath channels to improve the overall system performance in scenarios with limited data speeds and low energy requirements, such as Low-rate wireless personal area networks (LR-WPAN). Mathematical models in discrete-time domain for the conventional transmitting side with multiple access operation, the generalized non-selective Rayleigh fading channel, and the proposed receiver are provided and described. A rough theoretical bit-error-rate (BER) expression is first derived by means of Gaussian approximation. We then define the main component in the expression and build its probability mass function (PMF) through numerical computation. The final BER estimation is carried out by integrating the rough expression over possible discrete values of the PFM. In order to validate our findings, PC simulation is performed and simulated performance is compared with the corresponding estimated one. Obtained results

The demand for ubiquitous telecommunications services forces operators to have a special concern about signal quality and the coverage area they offer to their customers. This was usually checked by using suitable propagation models for Single Input Single Output (SISO) systems, which are no longer the case for new and future mobile generations, such as 5G and beyond. To guarantee good signal quality coverage, operators started to replace these models with Multiple Input Multiple Output (MIMO) ones. To achieve the best results, these models are usually calibrated with Drive Test (DT) measures; however, the DTs available for MIMO propagation models are sparse, in contrast to SISO ones. The main contribution presented in this paper is a methodology to extend the propagation models of SISO systems so they can be applied in MIMO sytems with Single-Carrier and Frequency-Domain Equalization (SC-FDE), while still using DTs acquired for SISO systems. This paper presents the impact on Bit Er...

In future high-speed self-routing photonic networks based on all opticalall-optical time division multiplexinged (OTDM) it is highly desirable to carry out packet switching, clock recovery and demultplexing in the optical domain in order to avoid the bottleneck due to the optoelectronics conversion. In this paper we propose a self-routing OTDM node structure composed of an all-optical router and a demultiplexer based on the symmetric Mach-Zehnder (SMZ) for high bit rate OTDM packets. Here, we investigate both numerically and by means of simulation the SMZ noise and crosstalk characteristics of the SMZ and the bit error rate (BER) performance of the proposed OTDM node. For BER of 10-9 and the total bit rates of 100 and 200 Gb/sGbps the power penalty incurred are about 2 and 2.5 dB, respectively compared with 2.5 Gbps back-to-back (B-B) system.